|
|
Laboratory of Synapse Structure and Function | |||||
| About | Anatomy | Links | Publications | Search | Tools | |
by JCF 2/25/02
To review the current settings, set the RUN/SET switch to SET. The display will show the day (as a number) and the first ON/OFF switch time. Push the Rev button to see the next ON/OFF switch time and day.
To clear individual settings, switch to the PROG mode. Select the day to program by entering the number corresponding to the day (0-9). Use the Rev button to cycle through the settings for that program day. Use the Clear button to remove any unwanted switch times. When done, switch the RUN/SET switch to RUN to save the settings.
To enter new settings, switch to the PROG mode. Enter the day to be programmed. You can program each day separately or program all days at once. To program all days enter 0 for the day to program. (Note that the switching times on a given day will be the combination of switch times entered directly for that day and those entered for all days, so make sure that the individual day values are cleared.) Enter the switch times following the instructions in the Intermatic handbook located inside the control box. Be sure to enter AM or PM after entering the digits. When done, switch the RUN/SET switch to RUN to save the settings.
| Last Updated: 2/25/02 |